Square D Digest 179

TeSys™ Ultra Combination Motor Controllers Refer to Catalog MKTED210011EN

Motor Starters and Protectors

www.se.com/us

Accessories

Table 17.86: Communication Modules [16][17] Communication modules allow the TeSys Ultra starter to be connected directly to the network. They are for use with advanced or multi-function control units (24 Vdc only) and require a separate 24 Vdc power supply. Module Prewired Connector Catalog Number Modbus™ Communication LU9BN11C or LU9MRC LULC033 CANopen Communication LU9BN11L or LU9MRL LULC08 Profibus Communication LU9BN11L or LU9MRL LULC07 DeviceNet™ Communication LU9BN11L or LU9MRL LULC09 Table 17.87: TeSys™ Ultra Cabling Accessories—Power Bus Bars Description Application Pitch Standard Pack Catalog Number

Modbus

DeviceNet

45 54 72 45 54 45 54 72 54 —

1 1 1 1 1 1 1 1 1 1

GV2G245 GV2G254 GV2G272 GV2G345 GV2G354 GV2G445 GV2G454 GV2G472 GV2G554 GV1G09

For feeding 2 TeSys Ultra controllers For feeding 3 TeSys Ultra controllers For feeding 4 TeSys Ultra controllers For feeding 5 TeSys Ultra controllers Top feed for use with bus bars

CANopen

Profibus

3-Pole, 63 A Bus Bar

Terminal blocks

Table 17.88: Control Circuit Accessories [18] for placement on power base. Accessory Application Technical Data

Catalog Number LUA8E20

Mounting

Switches control circuit power via LUB● handle (NEC430-74 compliance)

Side mounting to LUB● and LU2B● only

5 A at 600 Vac 5 A at 250 Vdc

Control circuit contact block

Through-the-door operating mechanism (without trip indication)

NEMA 1, 12, 3R, 4, 4X Red/Yellow

Use to enclose TeSys LUB● only.

Kit

LU9APN44

Non-reversing

LUA4F11 LUA4F12 LU9BN11C LU9BN11L

Use with electronic or triac output controllers

Up to 150 Vac max.

Directly to coil terminals

Control circuit filters

Reversing

Non-reversing

Central control when using communication modules

Lower power terminals to communication module.

See Table 17.86 for usage.

Pre-wired connector

Reversing

LU9MRL

17 CONTACTORS AND STARTERS-IEC

[16] See page 17-27 for placement on the power base. [17] Communication capabilities can be integrated into existing automation architecture via a variety of protocols. [18] See Power Base and Plug-in Accessories, page 17-27

17-29

© 2024 Schneider Electric All Rights Reserved